Chatsworth, CA, March 2008 – Aitech Defense Systems Inc., the world’s first and largest independent manufacturer of open architecture board and subsystem level products for harsh environment defense, aerospace and astronautics applications, has upgraded the high performance C108 single board computer (SBC), used in both new and legacy military embedded applications, to include an 8 GB USB SSD (solid state drive).

Connected to an available onboard USB host controller, the soldered USB SSD features an integral disk controller that enables high-speed USB port data transfers and provides automatic wear leveling and auto block management to ensure maximum longevity of the media. The USB SSD enables convenient file storage and virtual elimination of application software overhead.

For newer applications, the rugged 6U single-slot VME SBC offers up to 1.4 GHz of processing power via the PowerPC (PPC) MPC7448 processor, the highest performing Freescale PowerPC.  For legacy applications, the board features pin-to-pin backplane and I/O compatibility with previous Aitech processor boards employing the PPC MPC74xx processor family allowing easy, cost-effective upgrades to newer technology.

As with all Aitech SBCs used in military embedded applications, including mission management computers, heads-up display controllers, radar and sonar processors and advanced IED (Improvised Explosive Device) autonomous vehicle protection subsystems, the C108 provides numerous I/O capabilities for exceptional flexibility.

The C108 combines low power with high performance for reduced heat generation and increased reliability. Its pin compatibility reduces upgrade, O&M (operating and maintenance) and logistics expenses for our existing users of Aitech’s C10x Series.

In addition to the new USB SSD, the C108 supports new and legacy systems via a range of diverse I/O interfaces including a Gigabit Ethernet port, two Fast Ethernet ports, two dual-redundant MIL-STD-1553B interfaces, two USB ports, eight serial ports and 16 discrete I/O channels. Two PMC expansion slots enable standard, quick and easy increases to the board’s functionality.  For new programs, Aitech has added an onboard, optically-isolated CAN Bus 2.0B to interface with modern vehicle electronics and major functional subsystems without sacrificing one of the on-board PMC sites as well as to reduce modern subsystems costs.

A Discovery™ system and memory controller on the C108 work together to perform as both the processor’s memory controller and as the high-speed crossbar bridge to the PCI bus.  The C108 features two independent PCI buses to maximize PCI bus utilization and to enable various configurations.  The first bus can operate at 33/66 MHz, while the second operates only at 33 MHz to help separate fast and slow devices and enable each to operate at its maximum speed.  Both buses support 64-bit operation and fully comply with PCI Rev. 2.2.

In addition to the 1 GB of onboard, soldered, ECC-protected fast SDRAM, the C108 features other memory arrays such as 128 MB of Flash for user application storage,
32 MB of Boot Flash memory and up to 4 GB of high-density Flash for mass data storage.  128 kB NVRAM for user/application-specific parameter storage that does not require an external power supply during power down is also included.

Other features of the high performance C108 include eight 32-bit timers that provide high-resolution timing as well as long interval counting and two integrated digital temperature sensors for thermal management and protection.  Two watchdog timers allow the user to set a programmable time-out interval, which will reset the board providing an extra level of software and subsystem reliability.

An extensive firmware package with startup firmware (boot software), an AIMon monitor/debugger tool and an AIDiag diagnostic tool and BIT that can be executed during power-up or after the board has been booted is also included. 

A board support package (BSP) for the new C108 is available for WindRiver VxWorks as well as Green Hill’s INTEGRITY and INTEGRITY-178B, with other real time operating systems (RTOSs) available upon request.  The two mechanical formats of the SBC are air-cooled per ANSI/VITA 1-1994 and conduction-cooled per IEEE 1101.2.  The board’s custom metal frame provides exceptional rigidity and shock resistance in addition to providing an array of stiffeners for rugged PMC boards.


For more information, please Contact our Sales Department.
All Rights Reserved. © Copyright 2006 by Aitech Defense Systems, Inc.
19756 Prairie Street • Chatsworth, CA 91311
Tel: (888) 248-3248 • Fax: (818) 350-6888 • E-Mail:

Defense Products: SBCs & General Processors | Peripherals & I/O | Memory Boards | PMCs | Power Supplies
Space Products: SBCs & General Processors | Peripherals & I/O | Memory Boards|

Rugged Enclosures: 1/2 ATR VME Enclosures | 3/4 ATR VME Enclosures | Full ATR VME Enclosures | VME Slot Enclosures
Ruggedization | Quality Assurance | COTS | Customer Support | Documentation Library | White Papers | Aitech History | Our Team | Why Aitech? | Our Expertise | Current Ad
| Campaign | Employment Opportunties | Press Releases | Trade Shows & Events |Contact Us | Find a Representative